Try cleaning the return canister float ball. If it is stuck in the up position the machine will not make vacuum. Check the gasket under the dirty water tank. If there's not a good seal/broken gasket, it won't have good suction.
It's possible your pump may have lost its prime. To check, turn off machine and hold the spray trigger for 30 seconds. Your pump belt could be broken. To check, turn the power off and unplug from the outlet, insert a flat head screwdriver in to the slot of the belt access door to release.
Locate the brush reset button on the lower back right of the vacuum. Press the button to reset the brushroll To ensure the brush has been reset, plug the vacuum back into the electrical outlet. Turn on the vacuum detent the vacuum to begin cleaning Turn the brushroll on.
Yes - this cleaner has a motor for suction so it will sound about as loud as a stick vacuum. It is a vacuum cleaner and floor scrubber all in one with an electric motor.
Be sure your vacuum is turned off and unplugged before performing any maintenance, Before you begin, you will need a Phillips screwdriver. Remove the hose by pulling one end out of the base and turning the other end counter-clockwise and out. Then check the foot hose on the back of the machine towards the bottom.
You might not be using enough fresh cleaning solution when cleaning. Make sure to hold the trigger to leave an even finish on your floor. Streaking can also occur if you use too much water during passes. After making wet passes, release the trigger to go over the wet area without spraying.
You might not be using enough fresh cleaning solution when cleaning. Make sure to hold the trigger to leave an even finish on your floor. Streaking can also occur if you use too much water during passes. After making wet passes, release the trigger to go over the wet area without spraying.
If machine is leaking from the side vents: There may be too much foam building up within - be sure to use the recommended amount of formula as indicated on the clean tank. Also be sure to use the proper CrossWave formula (not portable or upright cleaning formulas)
Yes, you can add other multi-surface cleaners or vinegar except it is recommended that during your warranty period to use the Bissel multi-surface cleaner to not void the warranty. Just make sure that after every use you thoroughly clean all parts to avoid clogging the spray nozzle.
About this item
- Every Purchase Saves Pets - BISSELL proudly supports BISSELL Pet Foundation and its mission to save homeless pets.
- Vacuum filter replacement.
- Easy to remove and clean.
- Use with BISSELL CrossWave.
- Replace every 3-4 months.
To start cleaning your hard floors, turn the machine ON pressing the HARD FLOOR button. Once the setting is selected, the dry vacuum will turn on. To turn OFF, press the HARD FLOOR setting a second time. Before each use, hold the solution spray trigger for 10 seconds to prime the system with cleaning solution.
The Hoover Floormate Deluxe beats the Bissell Crosswave on price. The Hoover vacuum has better suction which is useful if you're otherwise going to need to make multiple passes to clean up a mess. The Hoover model also does a better job of getting into tight spaces, corners and along baseboards.
Bissell CrossWave Pet Pro (purple version) vs Bissell CrossWave (green version) As you can see, there is an obvious design difference. Apart from that, the body is almost the same. Financially speaking, the newer model costs around $50 more (see the Price section above).
The Crosswave cannot be used on carpets, only areas rugs. This Bissell struggles a bit with liquid when it is up against baseboards or walls.
